Open Box Darkglass Electronics Alpha Omega 200 Bass Amplifier Head 200W

  
Open Box Darkglass Electronics Alpha Omega 200 Bass Amplifier Head 200W. Open Box, Like New Condition! The Alpha·Omega 200 is slimmer and lighter than ever. Packed with Aux-in and headphone output for quiet practicing and an intuitive push potentiometer for the mute and master control. Pre/bypassed with switchable ground lift making these amps reliable for all sorts of musicians with an ample array of possibilities.

The compactness and lightweight make them flawless and convenient for rehearsals and live gigs, while an EQ section enhances the definition and clarity of sound across the spectrum. Use this jack to connect your instrument via a standard ¼ mono cable. This knob controls the amount of distortion that the Alpha. It will cover a wide range of overdriven tones from subtle break up to overly distorted sounds.

Selects or mixes between the two distinct distortion circuits: Alpha is punchy, tight with a lot of definition, whereas Omega is simply brutal and raw. Use this knob to mix between the Clean signal and the Distortion signal (Alpha. Use this knob to change the low-end content of the signal.

This knob controls the mid content of the signal. Use this knob to change the high content of the signal. Use this knob to control the overall volume of the amplifier.

Use this push knob button to mute the amplifier. 150x52x157 mm (5.9x2.04x6.18 in).

Use this connector to connect the amplifier to your cabinet. This Speakon combo jack allows for either Speakon or ¼ speaker cable operation. WARNING: Do not use an instrument cable with this jack.

Using an instrument cable can damage your amplifier. Use this control to lift the ground of the DI XLR output. If you are experiencing ground noise in your DI signal try changing the setting of this control.

Use this connector to send your bypass signal to the console, mic preamp, interface, etc. The DI OUTPUT delivers only the bypass DI signal. Connect your Headphones and enjoy the analog cabinet emulation.

This input is routed only to the headphone output without cabinet emulation. Use this connector to feed electric power to the amplifier. 100 - 230 VAC, 50-60Hz.

Use this Switch to release the audio energy from your bass.